From the sack to the basin

Roast it wrong and nothing later fixes it

Boiling, drying, cracking, roasting, milling, kneading. Six jobs, and only two of them can be got wrong in a way that cannot be mended: the roast, which sets the colour and the smell for good, and the water at the basin, which decides whether any fat comes out at all.

See what came off this week
A metal pot standing over flames and burning logsThe first boil. Fuseini keeps it going from six until the pot stops rolling.

Four jobs before the water goes in

  1. Pale dry ground cracked into flat platesOne

    Spread and dried

    Boiled nuts go out on the hard floor in a thin layer and stay there until a nut snaps instead of bending. A thick layer sweats underneath and comes up sour, so they are raked out thin and turned.

  2. Split dried nut shells spread out in a thick layerTwo

    Cracked, shell off

    Each nut is cracked and the kernel picked out of the shell. Shell left in the heap burns before the kernel does and puts a scorched smell through the whole roast, so the picking is slow on purpose.

  3. A dark stone mortar with wooden pestles standing in itThree

    Roasted, then milled

    Kernels are roasted over wood and stirred until the colour turns. This is where the butter gets its colour and its smell, and no later step undoes it. Over-roasted kernels make a dark paste that smells burnt, and it smells burnt in the tub as well.

  4. A galvanised oval tub of water standing on dark boardsFour

    Kneaded with water

    The milled paste goes into a basin and water goes in beside it, a bucket at a time. Two hands work it round for close to an hour, until the paste gives up its fat and the fat rises.

Two hands folding a dark brown paste into a pale cream mass in a wide glass bowl

Why the water decides, and why it is hands

Roasted paste is fat held inside everything else that was in the kernel. Nothing squeezes it out. What breaks it loose is water worked through the paste until the mixture gives way and the fat gathers into a soft grey curd that floats.

Add too little and the paste stays stiff, the hand drags, and what gathers is dark and full of fine matter. Add too much and the fat never builds into a mass at all: it breaks into specks, stays in the water and pours away at the end. The window between the two is not wide, and it moves with the roast, with the weather and with the batch.

No machine on this yard reads that window. A pair of hands feels the paste change under them a minute before it shows, and that is why the work is hands and why the people who do it are named on the home page with the rate they are paid.

What happens after the skim

The arithmetic of one basin

Across the basin
40 cm

Straight sides, 30 cm deep. The same basin we sell.

One litre stands
0.8 cm

So the level in the basin is a direct reading of the water that went in.

Ten kilos of paste
10.5 litres

That is the figure every ratio on the home page is worked against.

Come and look at a basin

The floor runs from seven in the morning. If you are buying a lot, come on a Wednesday and watch one worked through from the mill to the skim before you take any of it.